Shut the saw off before backing out of a cut. Do not back out of a cut while the machine is running.The ceramic blade guides are excellent, but can be easily damaged if the installation procedure is done incorrectly. Do not attempt to change blades unless you have been checked out in the process.Be sure there is no metal (nails, screws, etc.) in the wood you intend to cut.

Failure to do this may result in operator injury and/or damage to the machine. The log, sled or fixture must be fully supported by the table at the blade. When cutting logs, the log must have a true, flat surface to rest on the bandsaw's table or be securely attached to a sled or fixture to ensure stability.Be sure to consult a Monitor if you need to change blades. If you want to saw logs or abrasive exotic woods such as teak, you must use your own blade.Not only is there information in there which may prevent you from bleeding on the shop floor and damaging the blade and machine, but it is full of good operating tips as well. You must get a check-out on the machine too. Before using this saw for the first time, read the owner's/safety manual.Here are those rules and important things to know about using this machine:

They are expensive to replace, so follow the rules below and take good care of that blade. The 1 1/4' blade will probably be a Laguna Resaw King with carbide teeth. This machine is for resawing and normally has a 1' or 1 1/4' blade installed.

Laguna lt 18 3000